检测认证人脉交流通讯录
-
REMARKS
APM-00-015
apm-8
Pensky-Martens Closed Cup Flash Point Tester 宾斯基-马丁闭口杯法闪点试验仪
标准附件
CODE
PART NAME
Qty
REMARKS
APM-02-001
Test Cup Assembly 油杯
1
320-00-035
Thermofuse 热熔丝
1
Pack of 5, with Insulation Tube. 5只装，带绝缘管
210-02-161
Gas Hose 9 x 16, 1.5m with Hose Bands 带夹箍煤气管
1
APM-04-431
Windscreen for apm-8 挡风罩
1
―――
apm-8 MANUALS 操作手册
1
Manuals for apm-8.
选购附件
CODE
PART NAME
REMARKS
070-00-068
Printer, BS2-80TS
BS2-80TS型打印机
Prints out test data and instrument settings. 仪器设置和试验数据的打印
070-00-281
Mini USB Keyboard 迷你USB键盘
Sample ID entering 样品名输入
2年备件选购
CODE
PART NAME
Qty
APM-02-001
Test Cup Assembly 油杯
1
320-00-035
Thermofuse 热熔丝
1
ABL-01-003
Electric Igniter, EI-8 电子点火头
2
APM-04-031
Temperature Sensor for apm-8 温度传感器
1
APM-03-032
Flash detector for APM-7/apm-8
1
仪器特点
1.SINGLE ACTION SETTING单一动作设定
The flash detector rings and the temperature sensor are permanently mounted on a swing-arm assembly, which allows an easy setting of the specimen闪点检测环和温度传感器一起组装在测试摇臂上，加样便捷
2. EASY OPERATION 操作简单
Select a test mode and enter the expected flash point; while the instrument executes the test, you are free to do other lab work. The instrument follows the exact procedures prescribed in the test method, and the completion of the test cycle is signaled by beeps. The test result is brightly shown on the color LCD module.只需选好试验模式，输入预期闪点，仪器就严格按照标准自动进行测试，实验结束蜂鸣报警，显示试验结果。
3.INTERCHANGEABLE IGNITION SOURCE 可互换的点火源
apm-8 is equipped with both gas and electric igniter as the ignition source. It only takes a few minutes to switch from gas to electric or vice versa.
气、电点火两用，切换便捷
4. DRAFT PROTECTION SHIELD COVER 保护罩
A FM4910 conforming cover insures the flame integrity. This material shall meet the numerical criterion of each index. (1)FPI(Fire Propagation Index)≤6 (2)SDI(Smoke Damage Index)≤0.4
********************************************************************************************************
5. DATA HANDLING 数据处理
The unit is equipped to store up to 200 test results and export to an optional printer or to a LIMS through an RS-232 port or USB memory.
试验结果可以保存200个，试验结果可以选购打印机打印，也可以通过USB, RS-232将数据导出到LIMS。
6. USB PORT USB接口
A USB port allows connecting USB keyboard for easy entering sample name and connecting USB flash memory for data copy to a PC or test conditions/parameters copy to the tester.
USB接口可以接USB键盘（选购件）用于样品名称的输入，也可以接闪存copy试验参数
6.PASSWORD PROTECTION 密码保护
With setting up password by the administrator, the device is protected against inadvertent change of parameters by the operator.
试验程序有密码保护功能，可以防止误操作
7. ALL-IN ONE DESIGN IN LIGHTWEIGHT 轻盈的一体式设计
The all-in-one design is much lighter than old model, APM-7 by approximately 30%, which is world's smallest class in volume.
比APM-7轻30%左右，也是全球体积最小的宾斯基-马丁闭口杯法闪点试验仪
规格
机型
一体式设计，微处理器控制
试验标准
ISO 2719, ASTM D93, GB/T261
测试范围
室温到370℃
测试模式
标准模式
特殊模式
加热部
带式加热器
冷却装置
强制风冷
显示
5.7英寸彩色液晶显示
搅拌
100,250rpm(可选)
温度传感器
带不锈钢衬套的PT-100
闪点检测器
CRC 热电偶
点火源
气、电点火
大气压修正
通过内置的压力传感器自动补正
接口
RS-232C = 1
USB=1
安全设置
以下情况仪器停止运行，同时蜂鸣报警，屏幕显示
(a)高于预设闪点20℃以上或超过370℃时
(b)温度传感器故障
(c),闪点检测传感器故障
(d),热熔丝断开
(e)内置电池电能耗尽
(f) 检测臂未到位
(g)微机失控
(i)搅拌电机停转
气源（使用气点火时）
液化气或天然气（不超过10kpa）
电源
220/240 VAC, 50/60Hz
功率
最大720W
能耗
170Wh for 1 test
环境温度
10°Cto 35°C
外形尺寸
230mm(W) ×470mm (D) ×390mm (H) 17kg
